Connecting The Environmental Module To The Pulse Source Module - TA Instruments DISCOVERY XENON FLASH Getting Started Manual

Connecting the Environmental Module to the Pulse Source Module

NOTE: Refer to Appendix A: Connection Diagram
WARNING: Hand crush hazard is present. Do not place hands between the
Environmental module and the DXF.
AVERTISSEMENT: Un risque d'écrasement des mains est présent. Ne placez
pas les mains entre le module environnemental et le DXF.
Before making any connections, place the Environmental Module on top of the DXF so that they are
stacked; make sure to align the 4 pins on the bottom of the EM with the corresponding holes on the top of
the DXF. Allow an additional 28 cm (11 in) clearance to the right of the instrument for opening the
Autosampler on the EM.
Figure 5
Pins on the bottom of the Environmental Module (EM-200+ shown).
To connect the Environmental Module, you will need access to the DXF instrument back panel and the
Environmental Module back panel.
NOTE: Connect all cables before connecting the power cords to outlets. Tighten the screws on all cables.
CAUTION: Whenever plugging or unplugging power cords, handle them by the plugs, not by the
cords.
MISE EN GARDE: Chaque fois que vous branchez ou débranchez les cordons d'alimentation,
tenez-les par les fiches et non par les cordons.
WARNING: Protect power and communications cable paths. Do not create tripping hazards by
laying the cables across access ways.
AVERTISSEMENT: Protégez les chemins de câble électriques et de câbles de télécommunica-
tion. Ne créez pas de risques de déclenchement en posant des câbles sur les voies d'accès.
DXF Getting Started Guide
for a diagram of all instrument connections.
Page 22