Electromagnetic Compatibility Standards - TA Instruments DISCOVERY XENON FLASH Getting Started Manual

Electromagnetic Compatibility Standards

For Australia and New Zealand
AS/NZS CISPR 11:2007 Industrial, Scientific and Medical (ISM) Equipment - Radio-frequency Distur-
bance Characteristics - Limits and Methods of Measurement.
For Canada
ICES-003 Issue 5, February 2004 Information Technology Equipment (ITE) - Interference-Causing Equip-
ment Standard - Limits and Methods of Measurements.
For the European Economic Area
(In accordance with Council Directive 2004/108/EC of 15 December 2004 on the approximation of the
laws of the Member States relating to electromagnetic compatibility.)
EN61326-1:2006 Electrical Equipment for Measurement, Control, and Laboratory Use - EMC Require-
ments - Part 1: General Requirements.
Emissions: Meets Class A Requirements per CISPR 11.
Immunity: Per Table 1 - Basic Immunity Test Requirements.
For the United States
Code of Federal Regulations (CFR) Title 47 - Telecommunication, Chapter I - Federal Communications
Commission (FCC), Part 15 - Radio Frequency Devices, Subpart B - Unintentional Radiators for a Class A
Digital Device (FCC regulation pertaining to radio frequency emissions).
NOTE: This equipment has been tested and found to comply with the limits for Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interface when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference
at own expense.
DXF Getting Started Guide Page 5