Pc Setup Details - Omron SYSMAC CVM1 Series Operation Manual

PC Setup Details

Name
D:Startup processing
E:I/O refresh
F:Execute Detect low battery
control 1
Error on power off
CPU standby
Measure CPU-bus
Unit (CPU SIOU)
cycle
G:Execute
Execute process
control 2
I/O interrupts
Power OFF interrupt
Dup action process
Step timer
Startup trace
Indirect DM
binary/BCD
(*DM BIN/BCD)
Multiple use of
JMP000
Comparison error
process
444
Designate whether the user program (AUTOEXEC.OBJ) is automatically
transferred from the Memory Card to PC memory when the power is turned ON.
If this parameter is set to transfer the program, the program will be transferred
regardless of the PC's startup mode setting. Changes to this setting are effective
the next time the power is turned ON.
DIP switch pin #5 on the CPU can be turned ON to transfer both the user
program (AUTOEXEC.OBJ) and the PC setup (AUTOEXEC.STD). Refer to
information on the Memory Card for details.
(Default: Don't transfer)
This setting is fixed at "cyclic refreshing" in CVM1D PCs.
Designate whether battery errors are detected. Changes to this setting are
effective immediately.
(Default: Detect)
The following bits will be turned ON when a battery error is detected.
A40204 Battery Low Flag (PC or Memory Card)
A42614 Memory Card Battery Low Flag
A42615 PC Battery Low Flag
This setting is fixed at "Not an error" in CVM1D PCs.
Designate whether PC operation will begin or the CPU will standby during
initialization and until SYSMAC BUS/2 terminators are properly detected. If this
parameter is set for operation, PC operation will continue even if SYSMAC BUS/2
terminators aren't detected. Changes to this setting are effective immediately.
(Default: CPU standby)
Designate whether or not the time between CPU-bus Unit services is to be
measured. If measured, the cycle is stored starting at A310. Changes to this
setting are effective immediately.
(Default: Don't measure cycle)
This setting is fixed at "synchronous operation" in CVM1D PCs.
(This setting will be changed to "asynchronous" when the PC Setup is initialized
with SSS, but the setting is ignored in CVM1D operation.)
Not applicable in CVM1D PCs.
This setting is fixed at "No power OFF interrupt" in CVM1D PCs.
SFC instructions are not used in CVM1D PCs.
SFC instructions are not used in CVM1D PCs.
Designate whether a trace is executed automatically according to the preset
conditions when the power is turned on or the operating mode is changed.
Changes to this setting are effective the next time power is turned on.
(Default: Don't start trace.)
Designate whether indirect DM and EM addresses are binary (PC memory
addresses) or BCD (DM and EM area addresses). Changes to this setting are
effective immediately.
(Default: BCD)
Specify whether multiple JMP000 instructions can be programmed. Changes to
this setting are effective immediately.
(Default: Multiple use of JMP000 enabled)
Designate whether or not to start operation even though an I/O verification error
has occurred. This setting affects only the start of PC operation. The I/O
verification error is non-fatal, so PC operation will continue if an I/O verification
error occurs. Changes to this setting are effective immediately.
(Default: Run after error)
Operation
Section 7-2