Push-Buttons; Status Leds; Reviewing And Modifying Parameters - GE ASTAT XT QT 0008U Series User Manual

Push-Buttons

4.2
Scrolls through the display and programming menus of the ASTAT-XT.
Mode
When a mode name is displayed, pressing this button drills down to the parameters for that mode.
Select
When a parameter is displayed, pressing this button scrolls to the next parameter.
Allows the operator to increment adjusted values shown in the display. Operator should press this
button once to increment one value, or continuously to rapidly increment values up to the maximum
▲
value.
Allows the operator to decrement adjusted values shown in the display. Operator should press this
button once to decrement one value, or continuously to rapidly decrement values up to the minimum
▼
value.
Stores modified parameters only when you have scrolled through all parameters and Store
Settings Xxxxxx Parameters is displayed. After you store a parameter successfully Data
Set
Saved OK will display.
Resets the ASTAT-XT after a fault has been dealt with and the start command has been removed. This
Reset
cancels the fault displayed and allows you to restart the motor.
4.3

Status LEDs

Green On
Yellow Start
Green Run
Yellow Soft Stop
Red Stop
Save/Slow
Yellow
Speed
Dual
Green
set/Reverse
Red Fault
4.4

Reviewing and Modifying Parameters

Press the Mode key several times until you reach the required mode page.
Press the Select key to review parameters for this mode.
Once you reach the required parameter, use the ▼ or ▲ keys to modify its value.
To store the new parameters, press the Select key until the Store Settings Xxxxxx Parameters message
displays and then press the Set key. The Data Saved OK message will display for 2 seconds.
Note:
After completing parameter settings:
Turn control voltage OFF
•
• Wait 3 seconds
• Reconnect control voltage
Pressing Mode continuously increases the speed at which the parameters change.
14
Pressing the Set button at any other time has no effect.
15
• Control Keypad
21
15
Lights when the control supply voltage is connected to the ASTAT-XT.
Lights during soft start, indicating that motor supply voltage is ramping up.
Lights after completion of the starting process, indicating that motor is receiving
full voltage. This LED flashes during slow speed operation.
Lights during soft stop, indicating that the motor supply voltage is ramping down.
Lights when the motor is stopped.
Lights when Energy Saving is in operation.
Flashes when the motor is running in Slow Speed.
Lights when Dual Settings is in operation.
Flashes when the motor is running in Slow SP Reverse.
Lights upon operation of any of the built-in protections.
14