Manual Removal Of A Tape From A Drive; Manual Removal Of A Tape From A Rear Slot; Manual Removal Of A Tape From The Picker - ADIC Scalar 24 Installation And Operation Manual

Step 2 Press and
Step 3 Press to highlight Execute (

Manual Removal of a Tape From a Drive

To manually remove a tape from a drive, use the following steps:
Step 1 Position the picker to the left, which is away from the drive, using the Operator Panel.
Refer to the procedure above.
Step 2 Open the front door and remove the two magazines.
Step 3 Press the eject button on the drive and remove the tape.
Step 4 If the tape cannot be removed, send the drive to ADIC to be repaired.

Manual Removal of a Tape From a Rear Slot

To manually remove a tape from one of the rear slots, use the following steps:
Step 1 Position the picker to the far right. Refer to the procedure above.
Step 2 Power off the library.
Step 3 Open the front door and remove the two magazines.
Step 4 Reach into the back of the Scalar 24 and press up on the green lever to release a tape
from the rear slot.
Step 5 Gently pull the tape out toward you.

Manual Removal of a Tape From the Picker

To manually remove a tape from the picker, use the following steps:
Step 1 Position the picker to be accessible to you. Refer to the procedure above.
9-6
to select the target slot to move the picker to.
) and then press
Scalar 24
.
62-2301-02 Rev A