Develop ineo 5020i User Manual page 45

Error Message
Jam 2-sided
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray 1
Jam Tray 2
Jam Tray 3
Media Type Mismatch The media type specified
No Drum Unit
No Paper
No Paper Fed T1
No Paper Fed T2
No Paper Fed T3
No Paper MP
Cause
The paper is jammed in
the 2-sided tray or inside
the back cover.
The paper is jammed
inside the machine.
The paper is jammed in
the MP tray.
The paper is jammed in
the back of the machine.
The paper is jammed in
the indicated paper tray.
in the printer driver differs
from the paper type
specified in the machine's
menu.
The imaging unit is not
installed correctly.
The machine is out of
paper, or paper is not
loaded correctly in the
paper tray.
The machine failed to
feed paper from the
indicated paper tray.
The MP tray is out of
paper, or paper is not
loaded correctly in the MP
tray.
Action
Remove the 2-sided tray and open the
back cover to pull out all jammed paper.
Open the front cover, remove the toner
cartridge and imaging unit assembly,
and pull out all jammed paper. Close the
front cover.
Remove all jammed paper from in and
around the MP tray. Press Retry.
Open the fuser cover and remove all
jammed paper. Close the fuser cover.
Pull out the paper tray and remove all
jammed paper as shown in the
animation on the LCD.
Load the correct type of paper in the tray
indicated on the LCD, and then select
the correct media type in the Paper Type
setting on the machine.
Reinstall the toner cartridge and imaging
unit assembly.
• Refill paper in the paper tray. Make
sure the paper guides are set to the
correct size.
• If paper is in the tray, remove it and
load it again. Make sure the paper
guides are set to the correct size.
Pull out the paper tray indicated on the
LCD and remove all jammed paper.
Do one of the following:
• Refill paper in the MP tray. Make sure
the paper guides are set to the
correct size.
• If paper is in the tray, remove it and
load it again. Make sure the paper
guides are set to the correct size.
39