Table of Contents
Advertisement
Code
Description
The drive capacity of the
backup destination TeraStation
became full.
Code 11
Files larger than 4 GB were
backed up to the FAT32-
formatted USB drive.
Could not communicate
between backup source and
destination TeraStations.
Code 12
The settings of the TeraStation
were changed while the
backup job was running.
Code 14
Insufficient memory on the
TeraStation was not enough
so that the backup job did not
run.
Code 22
The connection was
Code 20
disconnected while the
backup job was running.
Corrective Action
Delete unnecessary files and folders.
Reduce the file size to 4 GB or less, or
change the file system to one other
than FAT32. Refer to the "Adding an
External Drive" section in chapter 4 for
compatible file systems.
Check that the Ethernet cable is
securely connected and that the hub
or other devices on the network are
turned on.
Do not change the settings while the
backup job is running. If changed, the
connection is temporarily terminated
and the backup job will fail.
Reduce the number of backup
destination files or disable any other
functions running at the same time.
Do not change the settings while the
backup job is running. If changed, the
connection is temporarily terminated
and the backup job will fail.
90
Log Example
rsync error: error
in file IO (code 11)
at receiver.c(389)
[receiver=3.1.0]
rsync: write failed on
"filename": File too
large (27)
rsync error: error in
rsync protocol data
stream (code 12) at
io.c(515)
ERROR: out of
memory in flist_
expand
rsync error: error
in IPC code (code
14) at main.c(655)
[receiver=2.6.8]
rsync: fork failed in
do_recv: Cannot
allocate memory (12)
rsync error: error
allocating core
memory buffers
(code 22) at util.c(120)
[sender=2.6.8]
rsync error: received
SIGINT, SIGTERM, or
SIGHUP (code 20) at
rsync.c(242)
Advertisement
Table of Contents
