RAID 0
Combines 2 or more drives into a single array. The usable drive space is the total space of all drives used. This simple
RAID mode offers faster performance than RAID modes that include parity. If a single drive in the array fails, then all
data in the array is lost.
JBOD
This mode uses the drives inside the TeraStation as individual drives. The drive space you can use is the total
capacity of all drives in the TeraStation. If any drives are damaged, then the data on that drive is lost.
Working with RAID Arrays
To change RAID settings, navigate to Storage > RAID in Settings.
Using JBOD
With JBOD, each drive in the TeraStation is addressed separately. To put drives from an array into JBOD, follow the
procedure below.
1
From Settings, click Storage.
2
Click
to the right of "RAID".
3
Click the array to delete.
4
Click Delete RAID Array.
5
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
6
Click OK when finished.
45