Table of Contents
Advertisement
Chapter 10 Appendix
TeraStation Does Not Work Properly
If an error occurs that prevents the TeraStation from booting up properly, one or more of the following symptoms
may occur:
• The power LED keeps blinking instead of turning into a solid glow; follow the procedure at the "Power LED Keeps
Blinking" section below.
• An "i" symbol is displayed with the TeraStation icon and the I61 message appears on NAS Navigator2; follow step
3 or later at the "Power LED Keeps Blinking" section below.
• An "i" symbol is displayed with the TeraStation icon and "EM" is added to your TeraStation's hostname on NAS
Navigator2; follow the procedure at the "Booting the TeraStation in Emergency Mode" section below.
• The LCD panel lights up in red with the "Invalid Firmware" message; follow the procedure at the "Booting the
TeraStation in Emergency Mode" section below.
If one or the above occurs, follow the appropriate procedures below to recover from the error.
Power LED Keeps Blinking
While the TeraStation's power LED keeps blinking, you may see the I61 message on NAS Navigator2 or the LCD
panel. In such a case, follow the procedure below to recover from the message.
1
Press and hold the power button for 3 seconds to turn off the TeraStation.
2
Turn it on while holding down the function button. You should press and hold the function button for 10
seconds even after pressing the power button.
3
When the power LED changes from blinking to glowing, open Settings from NAS Navigator2.
The following screen will appear.
4
Select the drive to install the firmware as "Primary Drive" and make sure that "Recover firmware" is selected
under "Action", then click OK.
215
Advertisement
Table of Contents
