Table of Contents
Advertisement
6.0 Operation
6.3 Start Up
Once power has been turned on, the display will show the following:
When the CLEAR key is pressed the backgage will move to coordinate the true position into the
computer. When the backgage is behind the preset the position will be counting down from
approximately 17.00 inches until the preset is achieved at approximately 5 inches. If the backgage is
in front of the presets the display will count up from 1 inch.
After preset the display will be as shown below:
The backgage may now be sent to a desired position by simply typing the dimension and pressing
SEND (see the Send Mode section, page 17, for more details).
6.4 Jogging Aid
A jogging aid is included as standard equipment with the Spartan 185 AEP. This tool allows the
operator to load and align paper without the need to place hands or arms under the knife or clamp.
To use, load the paper against the side and backgauge using the jogging aid (Figure 8). Remove the
jogging aid from the table, close the shield, clamp the paper, and make the cut.
12
PRESS CLEAR KEY
TO INITIALIZE
POSITION
REV. 1.0
5. 1 2 3
A:JOB
B:MAINT
Always remove the jogging aid from the table before making a cut.
Advertisement
Table of Contents
