Table of Contents
Advertisement
6.0 Operation
6.7 Clamp Only Feature
The Spartan 185 AEP is equipped with a "clamp only" feature which allows the user to send the
clamp down to the paper without cutting. This can be usefull to double check the clamping location
without making a cut. To use this feature, open the front shield and set the backgauge to the desired
position. Place the paper square against the backgauge and either side guide. Now close the front
shield then press and hold both clamp-only down buttons which are indicated in Figure 10 below:
A cut can now be made with the paper already clamped, or the clamp can be released without
making a cut. To make a cut, press and hold both cut buttons as described in section 6.6 . To
release the clamp without cutting, press and release the clamp up button which is indicated in Figure
11:
14
Figure 10 – Clamp Only Buttons
Figure 11 – Clamp Up Button
Advertisement
Table of Contents
