Table of Contents
Advertisement
Setting Table Inserts
The table inserts are preinstalled at the factory. They
should be adjusted so that the top surface of the insert
is level with the tabletop.
If any adjustment is necessary:
1. Place a straight edge across the inserts and table
top to determine if the inserts are level, high, or low
as compared to the table top.
2. If adjustment is needed, remove the two inner
inserts.
3. Remove the three screws in the top of the
outermost insert and remove the insert.
4. With the outer insert removed, you can see the
three insert leveling screws.
5. Using a 6mm hex wrench, turn the adjusting screws so that the insert sits flush with the
table.
6. Install the outer insert and secure in place with the three screws removed previous.
7. Install the one or both of the inner inserts so that least possible gap between the inserts and
the spindle exists. Do not allow the spindle or the cutter to contact the inserts.
Dust Collection
It is recommended that you use a dust collector (not included) when using this machine. The
minimum air flow requirements for this machine are listed below. The machine comes with a 4"
(101mm) dust port as part of the hood and guard assembly
The dust extraction equipment is to be switched on before commencing machining.
Air current speed is 20m/s for vacuum suction dust emission index.
When air current speed of dust collector device (in accordance with EN12779:2004) is not lower
than 20m/s, ensure machine can be normal exhausted. User must wear dustproof mask.
1. Required air flow: 1500 m3/h.
2. Ensure pressure drop of each dust collector outlet carrying air current speed: 1100Pa.
3. Wind speed of dust collector tube m/s:
Dry Chips: 20m/s,
Wet chips: 28m/s (water content is equal to18%)
22
22
Advertisement
Table of Contents
