Vecow RCS-9000 User Manual page 70

There are two 8-pin RJ-45 jacks supporting 10/100/1000 Mbps Ethernet
connections on the front side of RCS-9000. LAN 1 is powered by Intel
I219LMLM Ethernet engine, and LAN 2 is powered by Intel I210 Ethernet
engine. When LAN 1 works in normal status, iAMT 11.0 function is enabled.
When LAN 2 works in normal status, iAMT 8.0 function is enabled.
Using suitable RJ-45 cable, you can connect the RCS-9000 system to a
computer or to any other devices with Ethernet connection, for example, a hub
or a switch. Moreover, both LAN 1 and LAN 2 support "Wake" on LAN and pre-
boot functions. The pinouts of LAN 1 and LAN 2 are listed in the following chart:
Pin No.
1
2
3
4
5
6
7
8
Each LAN port is supported by a standard RJ-45 connector
with LED indicators to present active/link/speed statuses
of the connection. The LED indicator on the right bottom
corner becomes solid green when the cable is properly
connected to a 100Mbps Ethernet network; it becomes
solid orange when the cable is properly connected to a
1000Mbps Ethernet network. The left LED will keep blinking off when Ethernet
data packets are being transmitted or received.
LED Location
Right
Left
10/ 100Mbps
E_TX+
E_TX-
E_RX+
----
-----
E_RX-
-----
------
LED Color 10Mbps
Green/
Off
Orange
Blinking
Yellow
Yellow
1000Mbps
MDI0_P
MDI0_N
MDI1_P
MDI2_P
MDI2_N
MDI1_N
MDI3_P
MDI3_N
100Mbps
Solid Green
Blinking
Yellow
GETTING TO KNOW YOUR RCS-9000
®
1 8
1000Mbps
Solid Orange
Blinking
Yellow
61