Vecow RCS-9000 User Manual page 101

2.5.3 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin plugable
terminal block located on the front panel. Please use the following pictures to
find the general wiring configuration.
V+ :
Positive polarity of DC power input (Car battery+ for 12/24/36V)
V- :
Ground of DC power input (Car battery -/GND line to GND)
IGN :
Ignition signal input (ACC power of vehicle)
For testing purpose, you can refer to the picture above to simulate ignition
signal input controlled by a latching switch.
Note:
1. DC power source and IGN share the same ground.
2. RCS-9000 supports 6V~36V wide range DC power input in ATX/AT mode. In
Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
3. For proper ignition control, the power button setting should be "Power down"
mode.
©Vecow RCS-9000 User Manual
V+
IGN
V+
IGN
In Windows, for
example, you need
to set "When I press
the power button" to
"Shut down."
GETTING TO KNOW YOUR RCS-9000
92