Pkm GSP12-6ES Instruction Manual page 88

A
B
1
2
3
4
5
6
7
8
4. Fix the water drain hose properly, using a clamp (s. fig. below).
When installed to a fixed drain the water drain hose must be connected properly
to avoid any leaks.
When the sink is higher than 1000 mm the excess water cannot be drained
directly. Drain excess water in a suitable container which is held outside and lower
than the sink.
If the length of the water drain hose is not sufficient, apply to your authorised
service for an extension made from the same material as the original water drain
hose. The length of the water drain hose (including extension) should not
exceed 4 metres; otherwise, the performance of the appliance will be reduced.
I
NSTALLATION
I B:
NSTALLATION
B
ACK OF THE DISHWASHER
W
ATER INLET
W
ATER OUTLET
P
OWER CORD
W
ATER DRAIN HOSE
D
W
~ ~
88
A:
SINK
, Ø min. 40 mm
DRAINPIPE
RAINPIPE
S
INK
ORKTOP