Table of Contents
Advertisement
Available languages
Available languages
Always observe the instructions in chapter 6.2 S
.
PROGRAMME
4. The programmable delay period is 3, 6 or 9 hours. To activate the delayed
programme start, press the « D
operational status indicator of the desired delay period (3, 6 or 9 hours) goes on.
Each press of the « D
5. Close the door of the appliance properly.
6. The set cleaning programme starts automatically after the set delay time has
elapsed.
If the selected cleaning programme cannot be combined with the desired
programme function(s), these functions cannot be selected or will be cancelled
and the indicators switches off automatically.
The programme function « H
programmes.
Select this programme function if you want to clean max. six place settings or
less. If you put more than six place settings in the appliance and still select this
programme function, the cleaning effect of the appliance may be reduced.
The energy and water consumption of a cleaning programme may be reduced by
this programme function.
NOTICE! Do not use this programme function when the dishwasher is
fully loaded, otherwise the cleaning effect of the appliance will be
reduced.
The programme function « H
programmes (see also chapter 6.1 T
H
4. Switch on the appliance using the « O
5. The appliance is now in
6. Set the desired cleaning programme using the « P
the corresponding buttons to set the desired additional programme functions.
Always observe the instructions in chapter 6.2 S
.
PROGRAMME
ELAY
» -
ELAY
BUTTON
P
ROGRAMME FUNCTION
ALF LOAD
OW TO ACTIVATE THE PROGRAMME FUNCTION
« H
STANDBY MODE
» -
(«
BUTTON
increases the delay period by three hours.
: « H
ALF LOAD
» can be set for some cleaning
ALF LOAD
» may not be available for all cleaning
HE ADDITIONAL PROGRAMME FUNCTIONS
L
»
ALF
OAD
/ O
» -
N
FF
BUTTON
.
~
~
121
TARTING OF A CLEANING
») repeatedly until the
»
.
» -
ROGRAMME
BUTTON
TARTING OF A CLEANING
).
. Use
Advertisement
Table of Contents
