Table of Contents
Advertisement
Chapter 3 Function
Laser Control
This function is used to select the laser emission/stop.
This function makes it possible to stop unrequired laser emission while the system
is not in measurement operation.
Setting
Emission
*
The system will be in a data unfixed state temporarily if the laser control is set to
"Stop" and then set to "Emission."
● Setting Procedure
3
1
2
3
4
5
6
Laser emission is ON
Stop
Laser emission is OFF
indicates the default value.
Display the "System Setting" screen
while the system is in setting mode.
Press the [ENTER] key. The "Timing
Mode" screen will be displayed.
Press the [DOWN] key once. The
"Laser Control" screen will be displayed.
Press the [ENTER] key. The ON/OFF
will be displayed.
Press the [UP]/[DOWN] key to select
ON/OFF. (Example: Changing the
selection to OFF.)
Press the [ENTER] key to determine
the set value.
Function
3-40
Panel display
Advertisement
Table of Contents
