Trigger Points; Trigger Delay - Panasonic HL-G1 A-C5 Series User Manual

 Trigger Points
When the buffering mode is set to trigger mode, measurement data can be
loaded by setting the data as a trigger point at the generation of the trigger.
The setting range is in a range of 1 to the "accumulated amount" of data items.
The value is set to 300 by default.
• Accumulation will not start if the "trigger point" is set to a larger value than the
setting "accumulation amount."
• If the "Trigger Delay" function is set, the system can load the measurement data
from the trigger delayed data point after the setting trigger is generated.
 Trigger Delay
This function is used for delaying the timing of trigger detection when the
buffering mode is set to trigger mode.
This function is used to set the number of sampling times for the trigger delay. The
setting range is 0 to 65535.
The status during the trigger delay is indicated as "Accumulating." The trigger
delay is set to "0" by default.
For trigger mode:
This function is used to load measured data between the moment the preset trigger
is generated and the moment the delayed trigger point set by this function.
When the buffering rate is already set, the trigger delay will be counted with the
extended sampling in accordance with the setting.
3-51
Chapter 3 Function
3