To Display The Trace With Addresses Offset - HP 64751 User Manual

Chapter 7: Using the Emulation Analyzer
Modifying the Trace Display

To display the trace with addresses offset

• Use the offset_by option to the display trace command.
The offset_by trace display option allows you to cause the address information in
the trace display to be offset by the amount specified. The offset value is subtracted
from the instruction's physical address to yield the address that is displayed.
If code gets relocated and therefore makes symbolic information obsolete, you can
use the offset_by option to change the address information so that it again agrees
with the symbolic information.
You can also specify an offset to cause the listed addresses to match the addresses
in compiler or assembler listings.
Examples To display the trace with addresses offset by 154EH:
display trace offset_by 154eh <RETURN>
262