Table of Contents
Advertisement
Chapter 11: Emulator/Analyzer Interface Commands
wait
wait
This command allows you to present delays to the system.
The wait command can be an enhancement to a command file, or to normal
operation at the main emulation level. Delays allow the emulation system and
target processor time to reach a certain condition or state before executing the next
emulation command.
The wait command does not appear on the softkey labels. You must type the wait
command into the keyboard. After you type wait, the command parameters will be
accessible through the softkeys.
If you issue a wait command without any other options, the system will pause until
it receives a <CTRL>c signal.
Note that if set intr <CTRL>c was not executed on your system, <CTRL>c
normally defaults to the backspace key. See your UNIX system administrator for
more details regarding keyboard definitions.
Note that a wait command in a command file will cause execution of the command
file to pause until a <CTRL>c signal is received, if <CTRL>c is defined as the
interrupt signal. Subsequent commands in the command file will not execute while
the command file is paused. You can verify whether the interrupt signal is defined
as <CTRL>c by typing set at the system prompt.
426
Advertisement
Table of Contents
