Chapter 2: Plugging into a Target System
Step 3. Select the emulator clock source
Step 3. Select the emulator clock source
For 64751-66506 and lower numbered active probe printed-circuit boards, the
selection of the internal or external clock source is made with the "Micro-processor
clock source?" configuration question as described in the "Configuring for
Operation with Your Target System" section of the "Configuring the Emulator"
chapter.
For 64751-66508 and higher numbered active probe printed-circuit boards, the
selection of the internal or external clock source is made by positioning a jumper
module on the board.
If your active probe board number is 64751-66506 or lower, go on to Step 4;
otherwise, perform the following steps.
55