Table of Contents
Advertisement
Chapter 7: Using the Emulation Analyzer
Saving and Restoring Traces
Saving and Restoring Traces
The emulator/analyzer interface allow you to save trace commands and trace lists.
You can restore trace commands in order to set up the same trace specification.
You can restore traces in order to view trace data captured in the stored trace.
This section describes how to:
•
•
•
•
To save trace commands
• Choose File→Store→Trace Spec.
• Using the command line, enter the store trace_spec command.
You can save a trace command to a "trace specification" file and reload it at a later
time.
The trace command is saved in a file named "tspecfile.TS" in the current directory.
The extension ".TS" is appended to trace specification files if no extension is
specified in the store trace_spec command.
Examples
To store the current trace command:
store trace_spec tspecfile <RETURN>
264
Save trace commands.
Restore trace commands.
Save traces.
Restore traces.
Advertisement
Table of Contents
