Overview Of The Warm-Up Mode; Overview Of Toro Smart Power; Starting The Engine; Shutting Off The Engine - Toro Reelmaster 5610-D Operator's Manual

Overview of the Warm-Up Mode

When starting the machine in cold weather, warm-up mode limits the engine speed to low
idle for a short period after the engine is started, preventing potential component damage
from operating the machine with cold oil.
A snowflake icon
operate the machine until after the warm-up period.

Overview of Toro Smart Power™

With Smart Power, the operator does not have to listen to the engine speed in heavy load
conditions. Smart Power prevents the engine from bogging down in heavy cutting conditions
by automatically controlling the machine speed and optimizing cutting performance.
Note:
By default, the Smart Power feature is O

Starting the Engine

The fuel system automatically bleeds itself before starting the engine if you are
starting the engine for the first time, the engine has shut off due to lack of fuel, or you
have performed maintenance on the fuel system.
1. Sit on the seat, keep your foot off the traction pedal so that it is in N
parking brake, and ensure that the PTO switch is not engaged.
2. Turn the key to the O
An automatic timer controls the glow plug preheat for 6 seconds.
3. After preheating the glow plugs, turn the key to the S
Note:
engine starts. If additional preheating is required, turn the key to the O
then to the O
4. Run the engine at low idle speed until it warms up.

Shutting Off the Engine

1. Move all controls to N
low idle speed.
2. Turn the key to the O
3464-486A
on the display screen denotes when warm-up mode is active. Do not
/P
N REHEAT
Crank the engine for no longer than 15 seconds. Release the key when the
/P position. Repeat this process as required.
N REHEAT
EUTRAL
position and remove it from the switch.
FF
.
N
IMPORTANT
position.
, engage the parking brake, and allow the engine to reach
Page 5–19
, engage the
EUTRAL
position.
TART
position and
FF
Operation: During Operation