Updatenumgrprlist() - Polycom ReadiVoice Reference Manual

UpdateNumGrpRList()

Parameters
Parameter
vNumGroup1
vRoutingList1
vNumGroup2
vRoutingList2
vNumGroup3
vRoutingList3
vNumGroup4
vRoutingList4
Proprietary & Confidential
Stored procedure for assigning number groups to routing lists. To be used only
UpdateSysConfig_v2500()
after using
non-routed. Refer to the description of that procedure and especially to the
cautions it contains.
When a routed system is converted to non-routed, the existing bridge groups
and routing lists are deleted. The conversion process creates new bridge
groups and routing lists that have a one-to-one relationship to the bridges.
That is, each new routing list contains one bridge group that contains one
bridge. Using this procedure, you must assign each number group to one of
the new routing lists so that its access numbers are tied to a single bridge.
Each new routing list ID is the same as the bridge ID of the bridge to which it's
tied. So, to associate a number group with bridge ID 3, assign it to routing
list ID 3.
You can assign up to ten number groups to routing lists in one SPC. To assign
fewer than that, set the parameters you're not using to 0. All the number group
IDs and routing list IDs that you specify must exist in the database.
Specify all parameters. The constraints column shows specific value or range
constraints. For syntax rules and constraints applicable to all parameters, see
"Calling Stored Procedures"
Data Type Constraints
INT >0
INT >0
INT
INT
INT
INT
INT
INT
to change a routed system to
on page 4.
Description
Number Group 1.
New routing list ID for number group 1.
Number Group 2. Set to 0 if not assigning
another number group.
New routing list ID for number group 2. Set to 0
if not assigning another number group.
Number Group 3. Set to 0 if not assigning
another number group.
New routing list ID for number group 3. Set to 0
if not assigning another number group.
Number Group 4. Set to 0 if not assigning
another number group.
New routing list ID for number group 4. Set to 0
if not assigning another number group.
Current PSPI Functions
73