Installing The Defroster Sensor - Danfoss DHP-AL Installation And Service Instructions Manual

Figure 15: Front cover preparations.
6 Screw the three screws (4) into place from underneath in the
pre-drilled holes at the front edge of the outdoor unit.
7 Hook the lower edge of the front cover onto the three protrud-
ing screws.
8 Secure the front cover using three screws in the pre-drilled
holes (5).
Figure 16: Tighten the front cover in place.
9 Hook the cover at the front edge onto the front cover (6).
10 Secure the cover using a screw on each side (7).
7
Figure 17: Secure the cover.
4
11 Hook the cover onto the stand.
NOTE! Remember that the water that drips from the outdoor unit
during defrost must be able to drain into the ground. The outdoor
unit must therefore not be positioned on asphalt or slabs where
water cannot drain easily. If this is not possible, connect a hose to
the defrosting outlet and route it away from the outdoor unit.
4.4
5
Install the defroster sensor on the reverse of the outdoor unit.
6
VMBME102
Figure 18: Finishing by installing the cover.

Installing the defroster sensor

11