Table of Contents
Advertisement
2. Loosen 2 screws in locations shown below.
4. Bring the wiring from inside the wall through the opening created when the plate was removed in the previous step.
5. Wire the electrical box.
The receptacle and receptacle cover may be located in the manual pack and may need to be installed.
6. Feed any excess wiring into the wall and reinstall the plate onto the wall of the unit.
3. Slide electrical box plate towards the back of the unit and then out.
7. Reinstall electrical box and plate onto screws.
4. Bring the wiring from inside the wall through the opening created when the plate was removed in the previous step.
5. Wire the electrical box.
8. Tighten screws to secure.
NOTE: The receptacle and receptacle cover may be located in the manual pack and may need to be installed.
6. Feed any excess wiring into the wall and reinstall the plate onto the wall of the unit.
7. Reinstall electrical box and plate onto screws.
8. Tighten screws to secure.
Receptacle cover
Receptacle
installation
City Series CST60E |
65
Advertisement
Table of Contents
