Table of Contents
Advertisement
CITY SERIES 60
installation - general
12. Loosen 8 screws in the locations shown below (4 at front and 4 at
rear)—slide the burner to the left, away from the orifice, and lift it out.
t t o o o o l l t t i i p p
13. Remove burner orifice with a 3/8" wrench. Use another wrench to hold
the elbow behind the orifice. Discard the orifice. Reinstall the new burner
orifice LPG stamped #50 and tighten.
14. Remove the pilot retainer clip with pliers and pull off the pilot cap to
expose the pilot orifice.
920-406
46
| City Series CST60E
DETAIL A
SCALE 1 : 4
Burner screw locations
Slide burner to the left and lift out
Burner Orifice Location
A
2
15. Unscrew the pilot orifice with the Allen key, then replace it with the LPG
pilot orifice and the pilot cap provided in the kit.
16. Reinstall the pilot cap and pilot retainer clip.
17. Prior to installing the burner, adjust the aerations settings to 3/8" for LP.
Reinstall the burner (see step 11).
18. Make sure the aeration cap tab is inserted into the slot on the bracket.
Adjust the aeration handle if necessary.
Aeration cap tab
19. Reverse steps 1 to 11.
20. Ensure the pilot light is in the correct orientation to the burner. Recon-
nect the gas and electrical supplies. Start the appliance (see section
on lighting Instructions). Ensure that pilot and burner ignition are com-
pleted without delay. Check inlet and outlet pressures at full load. With
a soapy solution, leak test the entire system. Verify correct flame and
pilot appearance.
21. See Gas Pipe Pressure Testing in manual.
City Series
LP SYSTEM DATA
Min. Supply Pressure
Manifold Pressure - High
Manifold Pressure - Low
Orifice Size
Maximum Input
Minimum Input
Altitude
Installer Notice:
These instructions must be left
with the appliance
Slot on bracket
Aeration
handle
11" WC (2.73kpa)
10.5" WC (2.62 kpa)
2.9" WC (0.72 kpa)
#50 DMS
36,000 Btu/h (10.54 kW)
19,500 Btu/h (5.71 kW)
0-4500 ft (0-1372m)
.
07.14.21
Advertisement
Table of Contents
