Calibrating The Buttonhole Foot No. 3A; Updating The Machine Firmware - Bernina 570 QE User Manual

> Touch the icon «Default settings».
> Touch the icon «Delete data from USB Stick».
> Touch the icon «Confirm» to delete all data on the BERNINA USB Stick (optional accessory).

Calibrating the Buttonhole foot No. 3A

The Buttonhole foot with slide No. 3A and the machine are synchronized with each other and should only be
used together.
Prerequisite:
• The Buttonhole foot No. 3A is attached.
• The needle is not threaded.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Maintenance/Update».
> Touch the icon «Calibrate the Buttonhole foot No. 3A».
> To start the calibration, touch the button «Start/Stop».
> After the calibration is finished, close the window.

Updating the machine Firmware

The machine's current firmware and detailed step-by-step instructions for the update process can be
downloaded from www.bernina.com. In general, personal data and settings are automatically transferred
during a firmware update. For reasons of safety, it is also recommended to save data and settings on a
BERNINA USB stick (optional accessory) before the firmware update is started. If personal data and settings
should get lost during a firmware update, they can be transferred to the machine again afterwards.
The BERNINA USB stick (optional accessory) has been removed too early
NOTICE
Firmware has not been updated and the machine cannot be used.
> Remove the BERNINA USB stick (optional accessory) only after the update has been completed
successfully.
Setup Program
65