KVH Industries TracPhone V3 HTS User Manual page 65

TracPhone V3-HTS User's Guide
Network Configuration
66
To set up the network in a static IP configuration, follow these steps:
1. Make sure the system is activated for mini-VSAT Broadband
service.
2. Turn on the TracPhone system and make sure it is "Online."
The system must remain online to allow KVH to set up your
system over the satellite link.
3. Fill out the online form at www.kvh.com/staticip. Be sure to
read all of the details on this form. An additional monthly fee
for static IP service will apply.
Important!
Only the "User Ethernet 4" port on the ICM can be used to connect
static IP devices, as this port bypasses the ICM's local subnet to
connect directly to the built-in modem.
4. Connect your network device or computer to the "User
Ethernet 4" port on the rear panel of the ICM. Use a straight-
through CAT5 (or better) Ethernet cable with RJ45 connectors.
Figure 7-7 Static IP Configuration Wiring Example
(High-speed LAN)
ICM
User Ethernet
1 2 3 4
High-speed LAN
Bridge Ops PC Crew PC
5. At the TracPhone V3-HTS web interface or mini-VSAT
Manager, select the STATICIP_V3HTS network configuration.
Refer to "Selecting a Network Configuration" on page 61
details.
Wi-Fi
Mobile
Devices
Static IP
Accessory LAN
Firewall
Mobile
WAP Devices Engine Room PC
for