Advertisement
TracPhone V3/V3
Replacement Instructions
Technical Support
If you need technical assistance, please contact KVH Technical Support:
Europe, Middle East, Africa, Asia-Pacific:
Phone: +45 45 160 180
Email: mvbsupport@kvh.com
The following instructions explain how to replace
the LNB in a TracPhone
antenna.
NOTE: Your antenna might have parts that differ from
those pictured in this document. Such differences have no
bearing on the instructions unless noted otherwise.
Tools Required
This procedure requires the following tools:
• Phillips screwdrivers
• 7/16" open-end wrench
• 7/16" torque wrench set to 15 in.-lbs
KVH, TracPhone, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2011-2018 KVH Industries, Inc., All rights reserved.
54-0754 Rev. C | 72-0487, 72-0739, 72-0741
/V3
IP
HTS
®
V3/V3-IP/V3-HTS
LNB
North/South America, Australasia:
Phone: 1 866 701-7103 (U.S. only) or +1 401 851-3806
Email: mvbsupport@kvh.com
Figure 1: TracPhone Antenna LNB (V3-IP Shown)
1
Advertisement
Table of Contents
Related Manuals for KVH Industries TracPhone V3 LNB
Summary of Contents for KVH Industries TracPhone V3 LNB
- Page 1 • 7/16" torque wrench set to 15 in.-lbs KVH, TracPhone, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc. All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
- Page 2 Step 1 - Disconnect Power and Remove the Figure 2: Remove the Radome (V3-IP Shown) Radome Follow the steps below to swap out either an old or current model LNB. 1. Power off and unplug the ICM, or modem and control unit, to disconnect power from the #10-32 Screw (x3) antenna.
- Page 3 Step 2 - Identify the LNB Type Figure 3: LNB Types (from oldest to newest) There are four possible LNB types (see Figure 3). The replacement instructions are identical for each with one exception - the Legacy LNB must be replaced with an LNB-1 with attached filter.
- Page 4 Step 3 - Replace the LNB Figure 4: LNB RF Cable and Mounting Screws (LNB-2 shown) Follow the steps below and refer to Figure 4 to replace the LNB. Important! Before removal, note the orientation of the LNB, as shown in Figure 4, and be sure to match this orientation when installing the replacement LNB.
Need help?
Do you have a question about the TracPhone V3 LNB and is the answer not in the manual?
Questions and answers