KVH Industries TracPhone V3 HTS User Manual page 103

Hide thumbs Also See for TracPhone V3 HTS:
Table of Contents

Advertisement

TracPhone V3-HTS User's Guide
Troubleshooting
108
No.
Description
222
Warning: The antenna's internal temperature exceeds
acceptable limits. Turn off the system and allow it to cool. If
the problem persists, contact KVH.
234
Error: The antenna is not receiving satellite signal strength
(RSSI) data from the ICM. Try these steps:
• Turn the ICM off, then back on.
• Check the wires on the back of the ICM.
• Check the power/data cable.
235
Error: The antenna has lost RF communications. Contact
KVH.
240
Error: The antenna's LNB is not receiving the proper power
from the ICM's receive (RX) RF cable. Check the RX RF
cable.
241
Error: The antenna's main board detects a power failure.
Contact KVH.
265
Warning: The GPS is unable to acquire a fix. Check for
blockage or RF interference around the antenna.
271
Error: The ICM is incompatible with the antenna's LNB.
The LNB is configured for HTS, while the ICM is not.
Contact KVH.
401
Warning: No NMEA 0183 heading input detected. Check
the NMEA 0183 talker and its wires connected to the back
of the ICM.
404
Warning: Antenna is unwrapping its coiled internal cable.
Normal operation should resume within one minute.
410
Warning: The ICM has lost Ethernet communications with
its built-in modem. Check the jumper cable connecting
"B1" to "B2" on the back of the ICM.
411
Warning: The antenna cannot find an available service
satellite. You are located outside the coverage area.
412
Warning: The ICM is not receiving the proper DC voltage
from its power supply. Check the power cable
413
Warning: The antenna is waiting for GPS to acquire a fix.
414
Warning: The antenna is using position data from a backup
GPS device and not its built-in GPS.

Advertisement

Table of Contents
loading

Table of Contents