KVH Industries TracPhone V3 HTS User Manual page 113

TracPhone V3-HTS User's Guide
Troubleshooting
118
Antenna/ACU Status
Message
ANTENNA STATE
ANTENNA DC INPUT
CURRENT AZ/EL
CURRENT SKEW
IPACU DC INPUT
IPACU ENET MODEM
PORT STATE
MTA/RSM(GPRS) Status
Message
MTA STATUS
RSM (GPRS) STATUS
Description
General status of the antenna; must be
"Tracking" to connect to mini-VSAT
Broadband
DC voltage measured at the antenna's
circuit board; should be between
38 VDC and 44 VDC
Azimuth and elevation at which the
antenna is currently pointing; azimuth
is relative to vessel heading if heading
data is available, or the antenna's
"Forward" arrow (bow) if heading
data is not available
Current skew angle of the antenna's
LNB
DC voltage measured at the ICM's
power input; should be between
23 VDC and 25 VDC
Status of the ICM's Ethernet
connection to its built-in modem;
"Link" indicates he jumper cable is
connected between B1 and B2 on the
ICM's rear panel
Description
Status of the ICM's built-in MTA;
"Registered" indicates the MTA is
connected to the voice service
This message does not apply to the
TracPhone V3-HTS