Setting Switch S1 To Disable Vga Mode; Switch S2 - Planar DOME Md5/PCI Installation Manual

Installing the Md5/PCI Board in a Sun PCI Workstation

Setting switch S1 to disable VGA mode

The Md5/PCI board cannot operate as a VGA board in a
Sun PCI workstation. To disable VGA on the Md4/PCI
board, slide the DIP switches on switch S1 to the positions
shown in this table.
DIP Switch Settings on
Switch 1 to Disable VGA
DIP Switch

Switch S2

The default settings for switch S2, located to the right of
switch S1, are all OFF. If you change the default settings,
switch S2 will override the default monitor mode. For more
information, see "Using the Default Monitor Mode" on
page 91.
Position
1 OFF
2 OFF
3 ON
4 ON
81