To Modify The Owconfig File - Planar DOME Md5/PCI Installation Manual

94
3. Paste the copy into
OWconfig
append the copy to the end of the file.
When you install a new driver on your system, it over-
writes the
server/etc
file to the
ensure that the changes you make will not be overwrit-
ten when you update to newer versions of the DOME
driver. Make sure you edit these lines in the
directory only. If you uncomment these lines in both
directories, your system will ignore them.
4. Delete the pound sign (
to uncomment the lines.
5. Edit the lines to match each device you installed, and
save your changes.
To modify the OWconfig file
This section explains the first example from the sample
code on page 93, line by line. It also tells how to modify
those lines to match the devices you are installing.
class="XSCREENCONFIG" name="DOMEmd5pci0Config"
In this line of code, the
You can alter it, as long as other
do not have the same
device="/dev/md5pci0.0"
This line indicates that the board is an Md5/PCI board that
was assigned the instance of zero (0) by the system. The
second zero (0) indicates that you are using the first head of
the board. To modify this line for the device you are install-
ing, replace the first zero (0) with the instance your board
was assigned by the system. If you are using the second
head, replace the second zero (0) with a one (1).
/etc/openwin/server/etc/\
, and edit it there. If the
file in the
OWconfig
directory. By copying this section of the
/etc/openwin/server/etc
) at the beginning of each line
#
provided must be unique.
name
XSCREENCONFIG
.
name
Chapter 3
file exists,
OWconfig
/usr/openwin/\
directory, you
/etc
sections