To Support Vga Display With The Md5/Pci Board - Planar DOME Md5/PCI Installation Manual

Installing the Md5/PCI Board in a PC

To support VGA display with the Md5/PCI board

1. Remove the existing VGA board from your computer.
2. Enable VGA mode on the Md5/PCI board by following
instructions in "To enable VGA mode" on page 25.
3. Attach the VGA ribbon cable to the Md5/PCI board.
(The connector is keyed to ensure it is plugged in
correctly.)
Attaching a VGA ribbon cable
4. Install the Md5/PCI board by following the
instructions on page 27.
23