Issues With Digital Personal Workstations; Limitations Of The Digital Unix 64-Bit Pci Slots - Planar DOME Md5/PCI Installation Manual

Planar md5/pci display controllers: install guide
Hide thumbs Also See for DOME Md5/PCI:
Table of Contents

Advertisement

126

Issues with Digital Personal Workstations

The DOME device driver for the Md5/PCI board was
developed on the Digital 500au Personal Workstation.
This section describes issues encountered with that work-
station. These issues may not apply to all Digital Personal
Workstations.
The 500au workstation contains five PCI option slots:
• Three are 32-bit PCI slots.
• Two are 64-bit PCI slots. The 64-bit slots are longer and
are located toward the bottom of the computer.

Limitations of the Digital UNIX 64-bit PCI slots

The Md5/PCI board is fully PCI compliant, but the 64-bit
PCI slots in the 500au are not. To use the Md5/PCI board in
any of the 64-bit slots, you must first configure slots to
accept PCI boards.
If you want to configure the 64-bit slots to accept an
Md5/PCI board, see "To set the 64-bit slot to accept a
DOME PCI board" on page 119.
If you do not configure the 64-bit slot to accept the
Md5/PCI board, you must install the board in one of the
32-bit slots.
If you install your board in one of the 64-bit slots before
you configure the slot to accept it, a message similar to this
one will appear (the slot number may be different):
Illegal device detected on primary bus in
physical slot 4
Power down the system and remove the unsupported
device from slot 4
Chapter 4

Advertisement

Table of Contents
loading

Table of Contents