Connecting The Monitor; To Connect The Monitor To The Board - Planar DOME Md5/PCI Installation Manual

Installing the Md5/PCI Board in a PC

Connecting the Monitor

Once the Md5/PCI board is installed in your system, con-
nect the monitor(s) to the board with the cable provided.

To connect the monitor to the board

1. Attach the D-shell connector to the Md5/PCI board,
securing the connection with the screws on the
connector.
2. Attach each output cable to the appropriate BNC
terminal on your monitor. Refer to the monitor
documentation for more information.
Connecting the
cable to a
grayscale monitor
The cable labeling in the illustration above applies to
the DOME Md5/PCI cable. If you are using a cable
from another source, the cable labeling may differ.
31