JAI GO-5000M-PGE User Manual page 31

GO-5000M-PGE | GO-5000M-PGE-UV | User Manual (Ver. 2.0)
Line Source Item
LVAL
Pulse Generator 0 Out
User Out 0
User Out 1
Line 5 Opt In
NAND 0 Out
NAND 1 Out
Line Mode
Indicates the status of the item selected in Line Selector. (Input, Output or Internal)
Line Inverter
Sets the polarity of the selected input or output. (False or True)
Line Status
Indicates the status of the selected signal (input or output) (True=High, False=Low)
Line Format
Indicates the format of the line item selected in Line Selector (No Connect, TTL, LVDS, Opt Coupled or
Internal Signal).
Action Control
Action control settings allow the use of unicast or broadcast Action Commands as defined in the GigE
Vision 2.0 specification. ACTION_CMD messages received via the GVCP port can control the
camera's internal action signals provided the camera's action control settings match the settings of the
message received. This function is useful for triggering an action in multiple cameras at roughly the
same time. There are two action control inputs on this camera and they are connected to four triggers,
counter reset, counter, and timer.
When action control is used, the trigger input source should be set to Action 1 or Action 2 in advance.
Action Control
Item
Sets the device key value for the camera in a 32-bit register. This value must match the
ActionDeviceKey device_key value of the ACTION_CMD message in order for the message to be acted
upon.
Connect LVAL signal to line item selected in Line Selector
Note: Some items cannot select this item. Refer to
Connect Pulse Generator 0 signal to line item selected in Line Selector
Connect User Out 0 signal to line item selected in Line Selector
Connect User Out 1 signal to line item selected in Line Selector
Connect Opt In signal to line 5 in Line Selector
Connect NAND 0 signal to line item selected in Line Selector
Connect NAND 1 signal to line item selected in Line Selector
Description
Description
- 31 -
Main Functions
GPIO IN/OUT Matrix.