Elba EHS 635D1 SB Instructions For The Use - Installation Advices page 6

Built-in cooking hobs
Table of Contents

Advertisement

INSTALLER
IMPORTANT
The appliance should be installed, regulated and adapted to function by a QUALIFIED
INSTALLATION TECHNICIAN.
Failure to comply with this condition will render the guarantee invalid.
The appliance must be installed in compliance with the regulations in force in your
country and in observation of the manufacturer's instructions.
Installation technicians must comply to current laws in force concerning ventilation and
the evacuation of exhaust gases.
Always disconnect the appliance from the electrical supply before carrying out any
maintenance operations or repairs.
The appliance must be housed in heat-resistant units.
These tops are designed to be embedded into kitchen fixtures measuring 600
mm in depth.
The walls of the units must not be higher than work top and must be capable of
resisting temperatures of 105 °C above room temperature.
Do not install the appliance near inflammable materials (eg. curtains).
WARNING
When correctly installed, your product meets all safety requirements laid down for
this type of product category.
However special care should be taken around the underneath of the appliance as
this area is not designed or intended to be touched and may contain sharp or rough
edges, that may cause injury.
6
ADVICE
for the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ehs 645d1 sb

Table of Contents