Table of Contents
Advertisement
FITTING THE BATTERY IGNITION
SUPPLY
•
Remove pan supports and burners
from the cooktop.
•
Turn over the cooktop: be carefull to
lay on a soft surface so that it cannot
be damaged.
•
Connect the battery cable plug to the
socket as indicated in figure 2.6.
•
Fit the cooktop into the cabinet unit as
described in the Installation chapter.
•
Fix the battery holder to the cabinet
unit (figures 2.7 - 2.8) with 2 suitable
screws (not supplied). We suggest to
position the support as per figure 2.7,
on the left wall of the cabinet. Then
fix the cable to the cabinet wall with
suitable clamps (not supplied).
Important: do not secure the battery
support to the hob casing.
•
Insert a type AA battery (1.5 Volt) into
the battery holder (fig. 2.9).
NOTES
INSTALLATION OR REPLACEMENT:
•
Only use a type AA 1.5 Volt battery.
•
Check for correct polarity (fig. 2.9).
26
FOR
BATTERY
Important notes:
•
Remove the battery if the cooking hob
is not going to be used for a long time.
•
If
the
battery
immediately.
leaked liquid and make sure it does
not come into contact with clothes or
other items.
•
Clean
the
carefully before installing the new one.
•
Note: The battery is a potential source
of danger for children. Keep them
away.
•
Dispose of flat batteries properly.
leaks,
replace
Avoid
touching
battery
compartment
Fig. 2.9
it
the
Advertisement
Table of Contents
