Elba EHS 635D1 SB Instructions For The Use - Installation Advices page 11

GAS CONNECTION WITH A RUBBER HOSE
Important !
A rubber hose connection shall only be made if permitted by the applicable local
regulations.
The gas connection fitting (fig. 2.1) is made up of:
•
the appliance inlet pipe;
• the floating nut;
•
the brass elbow;
•
the sealing washers;
•
the appropriate hose holder (for LPG, TOWN GAS or NATURAL GAS).
Fig. 2.1
Note: if not already fitted on the inlet pipe, the hose holder is supplied
with the product in a separate kit; if not supplied with the appliance
it can be purchased by contacting Customer Care.
(Important: to be used ONLY IF PERMITTED by the local applicable regulations)
Turning the gas
connection fitting
1/2" G cylindrical
(ISO 228-1) female
Rubber hose (not supplied)
(internal diameter 8 mm)
Gas connection with rubber hose holder
1/2" G cylindrical
(ISO 228-1) male
Brass elbow
Sealing washer
Hose holder for
NATURAL GAS
or TOWN GAS
Sealing washer
Hose adaptor
for LPG
for LPG connection
Sealing washer
1/2" G cylindrical
(ISO 228-1) male
Hose clamp
(not supplied)
Floating nut
Appliance
inlet pipe
1/2" G cylindrical
(ISO 228-1) female
Hose holder for
NATURAL GAS
or TOWN GAS
Hose clamp
(not supplied)
Rubber hose (not
supplied) for TOWN
GAS or NATURAL GAS
connection
(internal diameter
13 mm)
11