Gas Section; Gas Installation Requirements - Elba E95-565 XD Instructions For The Use - Installation Advices

2

GAS SECTION

GAS INSTALLATION REQUIREMENTS

Important !
•
Before installation, make sure that the local distribution conditions (gas type and
pressure) and the adjustment of this appliance are compatible. The appliance
adjustment conditions are given on the plate or the label.
•
This appliance must be installed and serviced only by a suitably qualified,
registered installer with technical knowledge of both gas installation and
electricity. The installation or service must comply with the current editions of
the applicable standards, regulations, and codes of practice governing gas and
electrical installations.
•
Failure to install the appliance correctly could invalidate any manufacturer's
warranty.
This appliance is supplied for use on LPG (Cat. I 3+; check the gas regulation label attached
on the appliance).
This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation
label attached on the appliance).
•
Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only
and cannot be used on any other gas (LPG) without modification. The appliances are
manufactured for conversion to LPG.
•
Appliances supplied for use on LPG: they are adjusted for this gas only and cannot
be used on any other gas (NATURAL GAS) without modification. The appliances are
manufactured for conversion to NATURAL GAS.
If the NATURAL GAS/LPG conversion kit is not supplied with the appliance this kit can be
purchased by contacting the After-Sales Service.
INSTALLATION & SERVICE REGULATIONS
(UNITED KINGDOM ONLY)
It is a legal requirement that all gas appliances are Installed & Serviced by a competent
person in accordance with the current editions of the following Standards & Regulations or
those regulations appropriate to the geographical region in which they are to be installed:
• Gas Safety (Installation & Use) Regulations
• Building Regulations
• British/European Standards
• Regulations for Electrical Installation
Installation and service of any gas product must be made by a suitably qualified and
registered person competent on the type of product being installed or serviced and holding
a valid certificate of competence for the work being carried out. Currently the proof of
competence is the Accredited Certification Scheme (ACS) or N/SVQ that has been aligned
to the ACS.
It is also a requirement that all businesses or self employed installers are members of a
class of person approved by the Health and Safety Executive.
Failure to install the appliance correctly could invalidate any manufacturers warranty and
lead to prosecution under the above quoted regulations.
OR
13 13