Table of Contents
Advertisement
Service manual
Barkey warming center III DTM
7.7
Replacing the power switch
Removal:
►
Remove the heater insert (see Chapter 7.2).
►
Remove the cover plate (see Chapter 7.2).
►
Pull the spade connectors off the power switch.
►
Press the power switch forwards out of the front panel.
Refitting the power switch:
Refitting the power switch takes place in reverse order to removal:
►
Press the power switch into the front panel cutout until it engages.
NOTE
The label for the switched on condition (" I ") must be facing upwards when fitted.
blue
Figure 33: Power switch connections
►
Refix the cover plate (see Chapter 7.2).
►
Refit the heater insert (see Chapter 7.2).
32
Barkey GmbH & Co. KG - Gewerbestrasse 8 - 33818 Leopoldshoehe - Germany - Head Office: +49 (5202) 9801-0
brown
Customer Service: +49 (5202) 9801-30 Fax: +49 (5202) 9801-99 - e-mail: info@barkey.de
►
Push the spade connectors onto the
power switch:
–
the cable from the fuse goes to
the bottom contact
–
the cables from the controller cir-
cuit board go to the top contact
Service work
Advertisement
Table of Contents
