Table of Contents
Advertisement
E T C I n s t a l l a t i o n G u i d e
Installation Requirements
WARNING:
Important Safeguards
When using electrical equipment always follow basic safety precautions, including:
• READ AND FOLLOW ALL SAFETY INSTRUCTIONS. SAVE THESE
INSTRUCTIONS.
• Install this unit to an approved electrical enclosure only. This emergency device must
be installed in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause
an unsafe condition.
• Do not use this equipment for other than intended use.
Installation
The ALCR-PP (Power Pack) model is designed for permanent installation directly to an
electrical junction box or panel at the electrical lighting load or before the load in the
circuit. Reference
The ALCR-DIN (DIN-rail) model is designed to be permanently installed on a consumer
DIN rail 35mm (complies with DIN43880 and EN60715). Reference
Termination of the ALCR-DIN"
N o t e :
Once installation of the Automatic Load Control Relay is complete, reference
"Configuration of Time Delay" on page
Installation and Termination of the ALCR-PP
The ALCR-PP mounts directly to an electrical junction box or electrical enclosure at the
electrical lighting load or before the load(s) in the circuit. The ALCR-PP is fitted with a
1/2" nipple (standard 1/2" knockout).
Two sets of wire bundles are provided on the unit. One set is for emergency power input
and the other set is for sensing normal power. In addition, a single loop jumper is
provided for connection to a remote triggering device (normally closed, maintained dry
contact closure for fire alarms, etc.).
WARNING:
Autom atic Lo ad C ont rol R el ay
Before terminating the AC power wiring verify the breakers for the normal
power and emergency power are in the off position and follow the proper
lockout/tag out procedures per NFPA Standard 70E.
"Installation and Termination of the
on page 4.
The ALCR-DIN must be mounted in a suitably insulated or grounded enclosure,
such that live terminals are not accessible.
For indoor use only! Must install in an electrical junction box or wire way.
Follow local codes and restrictions.
Page 2 of 8
Automatic Load Control Relay
ALCR-PP".
6.
E l ect ronic Th eatre C ontro ls, In c.
"Installation and
Advertisement
Table of Contents
