Cable Routing And Conduit Access - ETC Echo Relay Panel Feedthrough Installation Manual

Cable Routing and Conduit Access

Echo Relay Panel Feedthrough has removable plates located on top, bottom and both sides to
accommodate conduit fittings for line, load, and feed wiring. Two knockouts, one on each
side of the user interface, are specifically provided for low-voltage (control) wiring.
Note:
Class 2 control wiring must be run separately from line, load, and feed wiring.
Note:
Remove a plate to punch conduit access as needed for line, load, and control
wiring. It is acceptable to remove the plate permanently if the unit is mounted in
direct contact with an adjacent Feedthrough panel.
Side panel conduit knockouts acco-
modate 12.7 mm (1/2 in) conduit or
bushings for low-voltage (Class 2)
control wiring only
Power Control Processor Mk2
Prepare for Installation
I/O compartment - located
behind the user interface,
provides access for low voltage
(Class 2) terminations
Removable Plates
13