True View Evo; Logging In To Apx15; Configure True View Wi-Fi - GeoCue True View 515 Hardware User's Manual

True View 515 Hardware User Guide

True View EVO

True View Evo is a 64-bit Windows® desktop application used for processing and exploiting True View
sensor data. It is GeoCue's LP360 point cloud exploitation product with the addition of a collection of
tools for True View sensor data workflows. Currently, True View Evo is available in two licensing levels:
•
True View Evo – This is equivalent to
workflow tools. It is limited to product areas of no more than 4 km
•
True View Evo Unlimited – this is the same functionally as True View EVO but the size limit is
removed.
True View EVO is the software used to post-process your raw flight data. EVO will generate a 3D LIDAR
point cloud in LAS format, colorize the point cloud, geotag the images collected, etc... It is based on
GeoCue's LIDAR point cloud exploitation software, LP360, and comes with all the
Advanced. Tools such as accuracy assessment, automatic and manual ground classification, and
contour/ surface exporting.
See the True View EVO User Guide

Logging in To APX15

It may be necessary to log in to the APX-15 to change settings such as lever arm offsets, or other
settings if advised by GeoCue Group Support. The instructions below explain how to configure the True
View Wi-Fi network and connect to the APX-15. Note that for firmware version3.0.5 and higher, Wi-Fi is
disabled by default. To turn Wi-Fi on , unplug the UMS drive from True View, then power on the True
View system.

Configure True View Wi-fi

1. Unplug the UMS from the True View 515.
2. Power on the True View 515 and wait for 30 seconds, or until "Trueview515" appears in your list
of Wi-Fi networks.
a. If you cannot find the network, turn off the True View 515, connect the UMS to laptop
and delete the file "TV_hostapd.conf"
3. If this network exists, connect to it with password "TrueView515."
4. Click Properties (Figure 50) of the TrueView515 Network
37
LP360 Advanced
for more information.
True View 515 Hardware User Guide
with the addition of the True View
2
of LIDAR data
same tools as LP360
10/26/2021