True View 515 Hardware User Guide
3. Place the drone in an open area where you intend to takeoff. True View will need an
unobstructed view of the sky. Avoid placing the drone near large metal objects such as
buildings or vehicles to avoid signal disturbance.
4. Insert the USB drive.
5. Turn on the True View unit with the switch located in the battery compartment (Figure 43).
6. Close the battery compartment door and lock the latch.
7. The True View will now cycle through the power up procedures.
3.
Disable Obstacle Avoidance
The integration of the True View 3DIS system will cause disruption to the M300's built-in obstacle
avoidance detection systems. If these systems are not disabled, they can cause erratic and potentially
dangerous behavior including loss of control of the drone. To disable obstacle avoidance, perform the
following steps:
1. Launch the DJI Pilot application, open a mission, or go into manual view.
2. Tap the Ellipsis menu (...) on the top right corner of the screen.
3. Tap the second icon from the top Obstacle Sensing Settings
4. Tap each tab for Horizontal, Upward, and Download tap the toggle button off for each
category. (Figure 44)
30
Figure 43 – True View Power Switch
IMPORTANT M300 Only
True View 515 Hardware User Guide
10/26/2021
Need help?
Do you have a question about the True View 515 and is the answer not in the manual?