Seagull Models TEMPEST DRAGON 15cc ARF Assembly Manual page 6

TEMPEST DRAGON 15cc ARF
Ater both ailerons are securely hinged,
irmly grasp the wing panel and aileron to
make sure the hinges are securely glued and
cannot be pulled out. Do this by carefully ap-
plying medium pressure, trying to separate
the aileron from the wing panel. Use caution
not to crush the wing structure.
7.
Note : Work the aileron up and down sev-
eral times to "work in" the hinges
and check for proper movement.
INSTALL THE AILERONS
CONTROL HORN
Locate the aileron control horns. he taller
control horn is used for the ailerons, and the
shorter horn for the laps.
1.
Ailerons control horn
Use sandpaper to scuf the bottom of the
aileron and lap control horns. Use a paper
towel and isopropyl alcohol to remove any
oils or debris from the control horns.
6
2.
Check the it of the control horns to
the aileron and lap. hey should rest lush
against the control surface as shown.
3.
Place low-tack tape 1/32 inch (1mm)
from the control horn slot. his will pre-
vent epoxy from getting on the control
surface when the control horns are glued
in place.
4.
Remove the control horns from the
control surfaces. Apply epoxy to the slot
in the aileron and lap. Make sure the
epoxy gets into the slot for a good bond
between the surfaces and control horn.
Instruction Manual.