Seagull Models TEMPEST DRAGON 15cc ARF Assembly Manual page 18

TEMPEST DRAGON 15cc ARF
5.
On the ie wall has the location for the
throttle pusshrod tube (pre-drill).
Slide the pushrod tube in the iewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the ie-
wall and the fuel tank mount.
Connect the Z-bend in the 450mm
throttle pushrod to the outer hole of the
carburetor arm.
Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four M4x30mm machine
screws to secure the engine to the mount
as shown.
6.
18
4mm
M4x30mm
7.
8.
M4 lock Nut
Reinstall the servo horn by sliding the
connector over the pushrod wire. Center
the throttle stick and trim and install the
servo horn perpendicular to the servo
center line.
9.
Move the throttle stick to the closed po-
sition and move the carburetor to closed.
Use a 2.5mm hex wrench to tighten the
screw that secures the throttle pushrod
wire. Make sure to use threadlock on the
screw so it does not vibrate loose.
Instruction Manual.
Pushrod wire