Table of Contents
Advertisement
Galactic RGB 720
System Setup
Language Settings
01) At start-up, while the starting screen is still on the display, press and hold down the MENU control for 2
seconds (do not turn the control).
02) Choose your preferred language by turning the MENU control to the left or right.
03) The available languages are: English, Simplified Chinese, Traditional Chinese and Japanese.
04) Press the MENU control to save your language choice.
After a few seconds, the device will automatically enter the currently active mode.
Basic Settings
01) At start-up, while the starting screen is still on the display, turn the MENU control (do not press
the control)
02) In this menu you can adjust:
•
Projector settings (Single color, R/G/Y – Red/Green/Yellow, Multicolor)
•
Scanner settings (10K, 15K or 20K)
•
LCD setup (Adjustment range from 0 to 53%, from dark to bright)
03) Turn the MENU control until the selection bar moves to the option which you would like to adjust.
04) Press the MENU control to enter edition mode.
05) Turn the MENU control to the left or right to, respectively, decrease or increase the adjusted values.
06) Once the option has been adjusted, press the MENU control again to save changes.
07) To exit the menu, select Exit on the screen and press MENU control.
08) The device will automatically enter the currently active mode.
Ordercode: 51340
16
Advertisement
Table of Contents
